Replacement of Broken Garage Door Springs

When you have broken garage door springs that need to be replaced you can either call a professional garage door company to handle them or you can do it on your own.

Garage door springs are long, heavy, and dangerous components that are used to raise and lower the garage door.  If you are experiencing the problem of broken garage door springs that need to be taken care then the following mentioned steps should be followed to get the job done. Go here for service that will help you to ensure that your broken garage door spring can be replaced easily.

The most important step that you should remember is to ensure that you have turned off the power to the garage door opener. So, there is no chance of getting electrocuted while performing the project. Pull the power cord of the opener to disconnect the garage door opener from the garage door. This rule is applicable both in newer and older versions of the garage doors. With the older models, you just need to remove the fuse or turn off the circuit breaker to disconnect the power supply.

Check the broken torsion spring and the new one to make sure that they are both the same. They should be inspected closely to make sure that they are the same in size, type, and dimensions. While picking a required spring, avoid grabbing them from others. Don’t touch the winding cones on the new springs while mounting. Use a marker or any other writing instrument to mark the torsion shaft ends. It is necessary to do because it helps you to maintain the balance of the garage door. When you have completed the work of releasing the broken spring and installing the new spring, the alignment of a garage door should be tested.

Wind the unbroken torsion spring off and unfasten the screws and bolts holding the torsion cones and spring brackets together, and remove the nuts and bolts completely. Once you have finished the task of the broken spring replacement project, it is time to re-installs other hardware. After completing this work, it is time to wind up the new spring. After completing all the steps, you need to check the balance of the garage door to make sure that it is level. In order to reduce the friction during garage door operations, you will have to apply any high-quality lubricant.

Once you have checked to make sure that your garage door is balanced and all the moving hardware is tightened in place, it is time to reconnect the garage door opener again. Yup, it is true that you should not play with a garage door but you need to open or close the garage door few times to make sure it is working correctly.

It is possible to replace the broken garage door spring on your own but you need to make sure that you are performing it carefully because it can be a dangerous project if not done properly. You could lose limbs, hands, fingers, or even your life.  It is always advisable that hire a professional garage door expert to replace the broken garage door spring safely.